Including filter system and high-performance PCBs filter.
PCBs are an industrial family of chemicals that persist in the environment and can occasionally find their way into drinking water. Also called polychlorinated biphenyls, these compounds were commonly used in older electrical gear and some manufacturing applications. Once they enter waterways, PCBs tend to stick around because they don’t break down easily. In Seaglades, homeowners often first hear about them from utility notices, neighbors, or private water testing, and understandably want straightforward ways to reduce potential exposure at home.
Because PCBs usually occur at very low concentrations, they won’t change the taste, smell, or appearance of your tap water. They can reach drinking supplies through legacy contamination, disturbed sediments, or runoff that carries pollutants into surface water. Even when Seaglades water looks clear, homeowners may be concerned about long-term exposure from everyday activities. Installing whole-house protection treats the water used for cooking, bathing, laundry and all household needs—not just a single faucet—so you’re addressing potential PCBs at the point where water enters your plumbing.
The single most effective whole-house filter for PCBs is a high-quality activated carbon system, typically using catalytic carbon or dense carbon block media engineered for strong adsorption. PCBs are hydrophobic organic chemicals, which makes them a good match for carbon’s adsorption properties rather than simple sediment traps. As Seaglades water flows through the carbon bed, polychlorinated biphenyls adhere to the carbon surface and are reduced before reaching fixtures, while the same carbon stage can also reduce many other organic contaminants with similar behavior.
To work reliably for a Seaglades household, an activated carbon PCB system needs adequate contact time and enough media volume sized to your home’s peak flow. A sediment pre-filter is commonly installed ahead of the carbon to prevent early clogging, but the carbon stage is the primary PCB remover. Because adsorption capacity will eventually be used up, correct sizing and scheduled media or cartridge replacement are essential. Mr. Pure Water can size and install a whole-house carbon system tailored to your home so PCBs are addressed at the main water entry point.