Including filter system and high-performance PCBs filter.
PCBs are industrial chemicals that linger in the environment and sometimes find their way into water sources; they’re also called polychlorinated biphenyls. Historically used in electrical equipment and some manufacturing, these compounds break down slowly and can persist in sediments and waterways. Homeowners in Washington Park may hear about PCBs from local water quality reports, neighborhood conversations, or private testing, since they’re not always obvious without targeted analysis.
Because PCBs usually occur at very low concentrations, you won’t detect them by sight, smell, or taste in tap water. They can enter drinking supplies through legacy contamination, runoff, or sediment disturbance and still pose questions about long-term exposure and everyday use. In Washington Park — where hard, tropical monsoon climate water can affect fixtures and appliances — treating the whole house makes sense so cooking, bathing, laundry, and all household uses are covered, not just a single tap.
The best single-filter choice for whole-house PCB reduction is a quality activated carbon system, typically using catalytic carbon or carbon block media formulated for strong adsorption. PCBs are hydrophobic organic chemicals, so they’re effectively captured by carbon media rather than simple sediment screens. As municipal water flows through the carbon bed, polychlorinated biphenyls stick to the carbon surface and are reduced before water reaches your plumbing, while also helping lower many similar organic contaminants.
An activated carbon PCB system must be sized for adequate contact time and sufficient media volume to handle your home’s peak flow, and a sediment pre-filter is commonly used upstream to protect the carbon from early clogging. Because adsorption capacity is finite, periodic cartridge or media replacement keeps the system performing. Mr. Pure Water can evaluate Washington Park homes and recommend the right whole-house carbon configuration to fit your plumbing and address PCBs at the point where water enters your house.