Including filter system and high-performance Sodium Chloride (Salt) filter.
Sodium chloride, often just called salt, can end up in your tap for a few reasons — from natural levels in source water to groundwater conditions or from certain treatment and regeneration processes. A small amount of dissolved mineral is normal, but higher salt can make water taste slightly briny and leave you wondering about what you’re drinking or cooking with. For Malabar homeowners watching their sodium intake, that invisible change in flavor can be especially concerning since you can’t see salt in a glass.
Elevated salt affects how water performs around the house: coffee, tea and ice may taste off, and fixtures can show a dull film that is tough to remove. Because sodium chloride dissolves completely, it won’t be trapped by ordinary sediment filters and boiling won’t remove it. Given Brevard County’s typically hard groundwater, it’s a good idea in Malabar to start with a test so you know whether the source is the incoming supply, a water-softening system, or another point of introduction.
When the goal is to remove dissolved sodium chloride, a reverse osmosis system is the most effective single-filter choice. RO relies on a semi-permeable membrane to separate dissolved salts from water, unlike carbon or sediment filters that mainly address particles, chlorine and odors. It’s the same core technology used for desalination and lowering total dissolved solids, so when salt is the main concern, picking the right RO membrane and configuration matters more than adding extra carbon stages.
For whole-house protection in Malabar, reverse osmosis is usually set up as a dedicated system with prefiltration to keep the membrane operating reliably. A pre-sediment filter helps prevent fouling, and carbon prefiltration will reduce chlorine that can shorten membrane life if present. Because RO creates a purified stream plus a rinse stream, correct sizing and professional installation are important to meet everyday household demand; Mr. Pure Water can test your water, locate the source of salt, and design a whole-house RO solution that works for your home.